There are just a few screws holding it in place. To replace the control, remove the console access panel at the back of the console. If the wiring is good the main board has failed. If the sensor is good then use your meter to ohm the wiring from the sensor connection to the main control board, if the wiring is bad, fix or replace the bad wire and that will take care of the error. Unplug the sensor from the wiring harness, and use a ohm meter to test the resistance of the sensor, it should around 1100 ohms at room temperature, if it's not close then its bad and that is causing the error. If you don't see it directly on the back of the range as shown in the picture above, then take the back access panel off and look on the right side and you will see it mounted there. Open the oven door and if you do not see two screws right beside the probe then yours is mounted on the back side of the range. It's either mounted to the back wall of the oven with two screws holding it in place or its mounted on the back side of the oven. The temperature sensor is the probe you see sticking out of the back wall of the oven. So the first thing you want to do is test the temperature sensor. There are three things that can cause the f10 error code, a bad temperature sensor, a bad electronic control board or bad wiring between the two. To fix Frigidaire range F10 error you will need to do a little troubleshooting first.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |